al rotator_installed ri Trendsetter_400/800_Auto The rotator_installed parameter is used to indicate to the firmware that the plate rotator option is installed on the unload table. In order for plates to be rotated, the rotator must be installed and the "al ri" parameter must be set to 1. For plates that are loaded automatically, the "state bay 1 rp" parameter must also be set to 1. Plates that are loaded manually will always be rotated if the rotator_installed parameter is set to 1. byte

1

0 to 1

cfg

../nvs/bay_state_rp.xmlNVS: bay rp

../nvs/plate_loc_state_rp.xmlNVS: plate_loc rp

..\..\ShowAllErrors.htmFirmware 0 Error Index

..\..\ShowAllCommands.htmFirmware 0 Command Index

..\..\ShowAllNVS.htmFirmware 0 NVS Index

Updated: Wed Jul 16 19:35:57 2008 PST